GP2Y1014AU detecting dust sensor PM2.5 (GP2Y1010AU0F)1, GP2Y1010AU0F dust sensors (1)2, 150ohm resistor (1)3, 220uF caps (1)4, 6pin connector (1) An overvi..
Environmental Combo Breakout - CCS811/BME280 (Qwiic)The SparkFun CCS811/BME280 Environmental Combo Breakout takes care of all your atmospheric-quality sensing needs with the popula..
MPU-6000 - Motion Processing UnitThe MPU-6000 is a serious little piece of motion processing tech! By combining a MEMS 3-axis gyroscope and a 3-axis accelerometer on the same silic..
LiPo batteries are a great way to power your projects. They're small, lightweight, and pack a pretty good punch for their size. Unfortunately, even the best batteries eventually ru..
This SHARP infrared distance sensor takes a continuous distance reading and returns a corresponding analog voltage with a range of 20cm (8") to 150cm (60").It can be usually applie..
This Slide Position Sensor is based on straight-slip potentiometer position sensor and can be combined easily with the Arduino IO/sensor expansion board. The sensor includes two ou..
This V2 Rotation Sensor is arduino compatible multi-ring rotation sensor. It is based on multi-turn precision potentiometer. It can rotate upto 10 laps. The voltage can be su..
This Rotation Sensor V1 is arduino compatible and can be rotated upto 300-degree. It is based on the potentiometer. With the Arduino IO expansion board, in combination, it can be v..
This is a digital tilt switch. It can be used as a simple tilt sensor. Simple plug to our IO/Sensor Expansion board, you can make amazing interactive projects. Spe..
Analog sensorsUses PH 2.0 socketSpecial sensor with Arduino expansion boardsSpecification:Type: AnalogThe definition of gray-scale sensor pin is (1) output (2) complex (3) powerDoc..
The flame sensor can be used to detect fire or other wavelength at 760 nm ~ 1100 nm light. In the fire-fighting robot game, the flame plays an important role in the probe, which ca..
This is a simple to use arduino motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the 'alarm'..